Clamp On Float Switch Sump Pump Alarm / LED Waterproof 12V Well, Septic

Description

Clamp on float alarm switch with waterproof surface panel mount alarm enclosure. Pulsating 80 DB alarm and Flashing LEDs. Option label tag. Comes with instructions.
The waterproof submersible float switch clamp mounts on the pump discharge tube with a steel hose clamp. Can also screw mounted to a flat, side mounted left or right or can be mounted horizontally.
#CAL1/Encl2/LBL/SWFLT1
For Sump pump well instalations
Label tag allows you to create a custom label. Label tag can be removed.
When 12 volts is applied the piercing tonal alarm and bright dual LED flash on and off in a one second interval cycle. The connections are two male 0.250 nylon insulated disconnect spade terminals on a wire 16 gauge pigtail. The leads are non-polarized and will work with 12 volts AC or DC.
ALARM
-Working Voltage: 12 Volts +/- 20%  (24 volts available upon request)
-Non-polarized connections.
-Anti-shock capability.
-Continuous Working Life ≥30000h
-Sound volume: 80db
-Sound type: intermittent one second on/off
-LED Brightness:≥500cd
-Minimum Working Current:≤20ma
-Connections male 0.250 fully insulated spade terminals. Alarm options:
-Buzzer Type: Piezoelectric
-Frequency 3900: ±500Hz
ALARM FLOAT SWITCH
SPST Single pole single throw. Switches 100ma max. Not for operating bilge pumps.
Multi
orientation
adjustable.
Wires 18 AWG, 20 inch.
Hose clamp shown is not included in this listing.
The junction box with
rubber o-ring seal is 3.0" x 2.5" x 2.5". The wire egress is a waterproof wire gland for up to 3/8" cable. Bulkhead mounts.